LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Volt Premier >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 1.5L (L3A) - Repair Instructions >> Repair Instructions >> Exhaust Gas Recirculation Cooler Replacement >> Installation Procedure

Installation Procedure

    Fig 1: EGR Cooler, Bolts And Gaskets
    GM4091536Courtesy of GENERAL MOTORS COMPANY
  1. Install a NEW gasket.(1, 2)
  2. Install Exhaust Gas Recirculation Cooler (4)
  3. NOTE:

    Do NOT tighten.

  4. Install Exhaust Gas Recirculation Cooler Bolt (3)
  5. Fig 2: EGR Temperature Sensor - Position 2, EGR Cooler And Bolts
    GM4091535Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Do NOT tighten.

  6. Install Exhaust Gas Recirculation Cooler Bolt (3) @Exhaust Gas Recirculation Cooler(1)
  7. Install the exhaust gas recirculation temperature sensor - position 2 (2) and tighten to 42 N.m (31 lb ft).
  8. Fig 3: EGR Temperature Sensor - Position 1, EGR Cooler And Bolts
    GM4091513Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Do NOT tighten.

  9. Install Exhaust Gas Recirculation Cooler Bolt (2)
  10. Install the exhaust gas recirculation temperature sensor - position 1 (1) to the exhaust gas recirculation cooler (3) and tighten to 42 N.m (31 lb ft).
  11. Tighten all 6 exhaust gas recirculation cooler bolts to 10 N.m (89 lb in)
  12. Fig 4: Thermostat Bypass Hose Clamp
    GM4091333Courtesy of GENERAL MOTORS COMPANY
  13. Connect Thermostat Bypass Hose (2) -
  14. Tighten Thermostat Bypass Hose Clamp (1) - Tighten
  15. Fig 5: EGR Cooler, EGR Cooler Water Bypass Outlet Hose, Heater Inlet Hose And Clamps
    GM4091518Courtesy of GENERAL MOTORS COMPANY
  16. Connect Heater Inlet Hose (2) @Exhaust Gas Recirculation Cooler (1)
  17. Connect Exhaust Gas Recirculation Cooler Water Bypass Outlet Hose (4) @Exhaust Gas Recirculation Cooler (1)
  18. Clamp (3) - Tighten
  19. Install Three-Way Catalytic Converter Replacement
  20. Fill the cooling system. Cooling System Draining and Filling