LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Volt Premier >> Repair and Diagnosis (Single Page) >> Hybrid/Electric Powertrain >> Cooling Systems >> Hybrid/EV System Heating And Cooling >> Repair Instructions >> Generator Control Module Coolant Pump Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Clamp And Coolant Hose
    GM4091139Courtesy of GENERAL MOTORS COMPANY
  1. Install Coolant Hose (1)
  2. Install Clamp (2)BO-38185  pliers
  3. Install the rear half of the generator control module coolant pump bracket (4).
  4. Install the generator control module coolant pump (3).
    5. Fig 2: Generator Control Module Coolant Pump Bracket And Nuts
    GM4091137Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Check the pump and the bracket for the correct original position.

  5. Install the front half of the generator control module coolant pump bracket (1).
    6. CAUTION:

    Fastener Caution

  6. Install the 2 generator control module coolant pump bracket nuts (2) and tighten to 9 N.m (80 lb in).
    7. Fig 3: Coolant Hose And Retainer
    GM4091136Courtesy of GENERAL MOTORS COMPANY
  7. Install Coolant Hose (2)
  8. Install Clamp (1)BO-38185  pliers
  9. Install Retainer (3)
  10. Connect Electrical Connector (4)
  11. Install Front Wheelhouse Liner Replacement (Left Side)Front Wheelhouse Liner Replacement (Right Side)
  12. Lower the vehicle.
  13. Fill the cooling system. Drive Motor Generator Power Inverter Module Cooling System Draining and Filling 
scientia non olet · About LEMON Manuals