LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Traverse LS, FWD >> Repair and Diagnosis >> Steering >> Steering Wheel And Steering Column >> Repair Instructions >> Intermediate Steering Shaft Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Intermediate Steering Shaft Components
    GM1853881Courtesy of GENERAL MOTORS COMPANY
  1. Position the intermediate steering shaft (2) in the vehicle.
  2. Connect the intermediate steering shaft to the steering column shaft.
    3. CAUTION:

    Refer to Fastener Caution .

    NOTE:

    A NEW intermediate steering shaft upper bolt has a thread locking adhesive patch on the threads.

  3. Install the NEW intermediate steering shaft upper bolt (1), and tighten to 22 N.m (16 lb ft).
  4. Connect the intermediate steering shaft upper seal (3) to the dash panel.
  5. Install the left side instrument panel insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
    6. Fig 2: Identifying Intermediate Steering Shaft Bolt
    GM1853880Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    A NEW intermediate steering shaft lower bolt has a thread locking adhesive patch on the threads.

  6. Connect the intermediate steering shaft to the steering gear. Install the NEW intermediate steering shaft lower bolt (1) and tighten to 25 N.m (18 lb ft).
    7. NOTE:

    Do not tear the intermediate steering shaft boot. Install the boot in the correct position.

  7. Install the intermediate steering shaft boot to the steering gear and to the intermediate steering shaft upper seal.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals