LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Traverse LS Base >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Diagnostic Information and Procedures >> DTC C0710: Steering Position Signal >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF and all vehicle systems OFF. Disconnect the harness connectors at the steering wheel speed position sensor and yaw and lateral accelerometer sensor. It may take up to 2 min for all vehicle systems to power down.
  2. Test for less than 10 Ω between the low reference circuit terminal 6 and ground.
    • If 10 Ω or greater 

      Repair the open/high resistance in the circuit between the X201 inline connector and the steering wheel speed position sensor.

    • If less than 10 Ω 
  3. Ignition ON.
  4. Verify a test lamp illuminates between the ignition circuit terminal 5 and ground.
    • If the test lamp does not illuminate 

      Repair the open/high resistance in the circuit between the X201 inline connector and the steering wheel speed position sensor.

    • If the test lamp illuminates 
  5. Ignition OFF and all vehicle systems OFF. It may take up to 2 min for all vehicle systems to power down.
  6. Test for less than 130 Ω between the serial data circuits terminal 2 and 3.
    • If 130 Ω or greater 

      Repair the open/high resistance in the circuits between the X201 inline connector and the steering wheel speed position sensor.

    • If less than 130 Ω 
  7. Replace the steering wheel speed position sensor.
scientia non olet · About LEMON Manuals