Installation Procedure

NOTE:

Do not refinish previously painted sensors. Excess paint build up will cause the sensor to be inoperative.

Paint the rear object sensor. Refer to Basecoat/Clearcoat Paint Systems .
Ensure the paint does not exceed 6 mils. Use a paint thickness gauge suitable for non-ferrous metals. Refer to Paint Gauges .

Fig 1: Rear Object Sensor Housing

Courtesy of GENERAL MOTORS COMPANY

NOTE:

Ensure the silicone decoupling ring is installed on the sensor to avoid sensor failure.

Insert the sensor into the housing.
Connect the electrical connector to the rear object sensor.
Install the rear bumper fascia. Refer to Rear Bumper Fascia Replacement (Acadia)Rear Bumper Fascia Replacement (Enclave)Rear Bumper Fascia Replacement (Traverse) .