LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Traverse LS Base >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Automatic Transmission - 6T75 (M7V M7X) - Diagnostic Information And Procedures >> Diagnostic Information and Procedures >> DTC P06AC-P06AE: Control Module Power Up Temperature Sensor >> Circuit/System Verification

Circuit/System Verification

  1. Ignition ON, clear the DTCs with a scan tool.
  2. Operate the vehicle at 64 km/h (40 mph) for 10 min.
  3. Verify DTC P06AC, P06AD, or P06AE is not set.
    • If any of the DTCs are set 

      Replace the Q8 Control Solenoid Valve Assembly.

    • If none of the DTCs are set. 
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  5. Verify the DTC does not set.
    • If the DTC sets 

      Replace the Q8 Control Solenoid Valve Assembly.

    • If the DTC does not set 
  6. All OK.
scientia non olet · About LEMON Manuals