Circuit/System Testing
- Ignition OFF, disconnect the WPR relay.
- Connect a test lamp between the control circuit terminal 86 and ground.
- Ignition ON, command the low speed wipers ON and OFF using the wiper switch. The test lamp should turn ON and OFF when changing between the commanded states.
- If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the BCM.
- If the test lamp is always OFF, test for a short to ground or an open/high resistance on the control circuit. If the circuit tests normal, replace the BCM.
- If all circuits test normal, test or replace the WPR relay.