LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Traverse LS Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Power Door Lock System And Release Systems >> Diagnostic Information and Procedures >> DTC B3140, B3145, B3150, or B3155: Unlock Switch Circuit, Lock Switch Circuit >> Component Testing

Component Testing

Driver Door Lock Switch

  1. Ignition OFF, disconnect the harness connector at the S13D Door Lock Switch-Driver.
  2. Test for infinite resistance between the signal terminal D and the ground terminal B with the switch in the open position.
    • If less than infinite resistance 

      Replace the S13D Door Lock Switch-Driver.

    • If infinite resistance 
  3. Test for infinite resistance between the signal terminal E and the ground terminal B with the switch in the open position.
    • If less than infinite resistance 

      Replace the S13D Door Lock Switch-Driver

    • If infinite resistance 
  4. Test for less than 2 Ω between the signal terminal D and the ground terminal B with the switch in the Lock position.
    • If 2 Ω or greater 

      Replace the S13D Door Lock Switch-Driver.

    • If less than 2 Ω 
  5. Test for less than 2 Ω between the signal terminal E and the ground terminal B with the switch in the Unlock position.
    • If 2 Ω or greater 

      Replace the S13D Door Lock Switch-Driver.

    • If less than 2 Ω 
  6. All OK

Passenger Door Lock Switch

  1. Ignition OFF, disconnect the harness connector at the S13P Door Lock Switch-Passenger.
  2. Test for infinite resistance between the signal terminal D and the ground terminal B with the switch in the open position.
    • If less than infinite resistance 

      Replace the S13P Door Lock Switch-Passenger.

    • If infinite resistance 
  3. Test for infinite resistance between the signal terminal E and the ground terminal B with the switch in the open position.
    • If less than infinite resistance 

      Replace the S13P Door Lock Switch-Passenger

    • If infinite resistance 
  4. Test for less than 2 Ω between the signal terminal E and the ground terminal B with the switch in the Lock position.
    • If 2 Ω or greater 

      Replace the S13P Door Lock Switch-Passenger.

    • If less than 2 Ω 
  5. Test for less than 2 Ω between the signal terminal D and the ground terminal B with the switch in the Unlock position.
    • If 2 Ω or greater 

      Replace the S13P Door Lock Switch-Passenger.

    • If less than 2 Ω 
  6. All OK