LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LS, Automatic CVT Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - JATCO CVT >> Diagnostic Information and Procedures >> DTC P0721: Output Speed Sensor Performance >> Component Testing >> K71 Transmission Control Module

K71 Transmission Control Module

  1. Ignition OFF, disconnect the harness connector at the B14A Output Shaft Speed Sensor.
  2. Connect the red lead of the J-38522  variable signal generator to the sensor signal circuit terminal 2. Connect the black lead of the J-38522  variable signal generator to the low reference circuit terminal 1. Plug the power cord of the J-38522  variable signal generator into the cigar lighter.
    NOTE: Testing for steps 2 - 4 is performed on the B14A Output Shaft Speed Sensor harness connector using the GY probes J-35616-2A  .
  3. Set the J-38522  variable signal generator to 12 volts, the Frequency to 30 and the Duty Cycle to 50%.
  4. Ignition ON. Verify the scan tool Transmission OSS parameter is between the following specified ranges as you rotate the frequency switch through the various selections.
    • If not within the specified range, replace the K71 Transmission Control Module.
    • If within the specified range.
  5. K71 Transmission Control Module OK.
scientia non olet · About LEMON Manuals