LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Sonic Premier, 4D Hatchback, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 1.8L (LUW LWE)) >> Specifications >> Fastener Specifications

Fastener Specifications

WARNING: This page is about a different variant/trim than selected.
Single Use Non-Threaded Fasteners/Components

Application
NOTE:

All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. 
Camshaft Cover Gasket
Camshaft Front Oil Seal
Camshaft Sealing Ring
Camshaft Oil Seal Ring
Camshaft Position Actuator Solenoid Valve Seal
Cylinder Head Gasket
Engine Coolant Thermostat Housing Seal
Engine Front Cover Gasket
Engine Oil Cooler Seal
Engine Oil Cooler Housing Seal
Exhaust Manifold Gasket
Intake Manifold Gasket
Intake Manifold Seal
Multiport Fuel Injector Seal
Oil Filter Cap Seal
Oil Level Indicator Tube Gasket
Oil Level Indicator Tube Seal
Secondary Air Injection Check Valve Gasket
Throttle Body Seal
Valve Stem Oil Seal
Water Pump Gasket
Single Use Threaded Fastener/Component Tightening Specifications

Application Specification
Metric (English)
NOTE:

All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. 
Automatic Transmission Flex Plate Bolt
  • First Pass:
 60 N.m (44 lb ft)
  • Final Pass:
 Plus 5 Degrees
Automatic Transmission Flex Plate to Torque Converter Bolt 60 N.m (44 lb ft)
Connecting Rod Bearing Cap Bolt
  • First Pass:
 35 N.m (26 lb ft)
  • Second Pass:
 Plus 45 Degrees
  • Final Pass:
 Plus 15 Degrees
Crankshaft Balancer Bolt
  • First Pass:
 95 N.m (70 lb ft)
  • Second Pass:
 Plus 45 Degrees
  • Final Pass:
 Plus 15 Degrees
Crankshaft Bearing Cap Bolt
  • First Pass:
 50 N.m (37 lb ft)
  • Second Pass:
 Plus 45 Degrees
  • Final Pass:
 Plus 15 Degrees
Connecting Rod Bolt
  • First Pass:
 35 N.m (26 lb ft)
  • Second Pass:
 Plus 45 Degrees
  • Final Pass:
 Plus 15 Degrees
Cylinder Head Bolt
  • First Pass:
 25 N.m (18 lb ft)
  • Second Pass:
 Plus 90 Degrees
  • Third Pass:
 Plus 90 Degrees
  • Fourth Pass:
 Plus 90 Degrees
  • Final Pass:
 Plus 45 Degrees
Engine Mount Bolt 58 N.m (43 lb ft)
Engine Mount Bracket Bolt 62 N.m (46 lb ft)
Engine Mount Bracket Bolt to Mount Bolt
  • First Pass:
 50 N.m (37 lb ft)
  • Second Pass:
 Plus 60 - 75 Degrees
Exhaust Camshaft Closure Bolt 30 N.m (22 lb ft)
Exhaust Camshaft Position Actuator Adjuster Bolt
  • First Pass:
 50 N.m (37 lb ft)
  • Second Pass:
 Plus 150 Degrees
  • Final Pass:
 Plus 15 Degrees
Exhaust Manifold Nut 20 N.m (15 lb ft)
Engine Flywheel Bolt
  • First Pass:
 35 N.m (26 lb ft)
  • Second Pass:
 Plus 30 Degrees
  • Final Pass:
 Plus 15 Degrees
Intake Camshaft Closure Bolt 30 N.m (22 lb ft)
Intake Camshaft Position Actuator Adjuster Bolt
  • First Pass:
 50 N.m (37 lb ft)
  • Second Pass:
 Plus 150 Degrees
  • Final Pass:
 Plus 15 Degrees
Steering Linkage Outer Tie Rod Nut
  • First Pass:
 30 N.m (22 lb ft)
  • Final Pass:
 Plus 128 Degrees
Timing Belt Idler Pulley Bolt
  • First Pass:
 20 N.m (15 lb ft)
  • Second Pass:
 Plus 120 Degrees
  • Final Pass:
 Plus 15 Degrees
Timing Belt Rear Cover Bolt 6 N.m (53 lb in)
Timing Belt Tensioner Bolt
  • First Pass:
 20 N.m (15 lb ft)
  • Second Pass:
 Plus 120 Degrees
  • Final Pass:
 Plus 15 Degrees
Transmission Mount Bolt
  • First Pass:
 50 N.m (37 lb ft)
  • Final Pass:
 Plus 70 Degrees
Transmission Rear Mount to Bracket Through Bolt
  • First Pass:
 80 N.m (59 lb ft)
  • Final Pass:
 Plus 45 - 60 Degrees
Water Pump Bolt 8 N.m (71 lb in)
Water Pump Pulley Bolt 20 N.m (15 lb ft)
Wheel Drive Shaft Nut 250 N.m (184 lb ft)
Reusable Threaded Fastener Tightening Specifications

Application Specification
Metric (English)
NOTE:

All fasteners listed in this table can be reused after removal. 
Air Conditioning Compressor and Condenser Hose Nut 19 N.m (14 lb ft)
Air Conditioning Compressor Bolt 22 N.m (16 lb ft)
Air Conditioning Evaporator Hose Assembly Nut 22 N.m (16 lb ft)
Camshaft Position Actuator Adjuster Closure Plug 30 N.m (22 lb ft)
Camshaft Bearing Cap Bolt 8 N.m (71 lb in)
Camshaft Closure Bolt 30 N.m (22 lb ft)
Camshaft Cover Bolt 8 N.m (71 lb in)
Camshaft Position Actuator Solenoid Valve Bolt 6 N.m (53 lb in)
Crankshaft Position Sensor Bolt 5 N.m (44 lb in)
Drive Belt Tensioner Bolt 55 N.m (41 lb ft)
Engine Coolant Thermostat Housing Bolt 8 N.m (71 lb ft)
Engine Front Cover Bolt 20 N.m (15 lb ft)
Engine Lift Bracket 22 N.m (16 lb ft)
Engine Mount Nut 58 N.m (43 lb ft)
Engine Oil Cooler Bolt 25 N.m (18 lb ft)
Engine Oil Cooler Inlet Pipe Bolt 25 N.m (18 lb ft)
Engine Oil Level Indicator Tube Bolt 15 N.m (11 lb ft)
Evaporative Emission Canister Purge Solenoid Valve Bracket Bolt 7 N.m (62 lb in)
Exhaust Manifold Brace Bolt 20 N.m (15 lb ft)
Exhaust Manifold Heat Shield Bolt 8 N.m (71 lb in)
Front Exhaust Pipe Bolt 20 N.m (15 lb ft)
Generator Bolt 35 N.m (26 lb ft)
Heat Exchanger Bolt 8 N.m (71 lb in)
Ignition Coil Bolt 8 N.m (71 lb in)
Intake Manifold Bolt 20 N.m (15 lb ft)
Intake Manifold Brace Bolt 8 N.m (71 lb in)
Intake Manifold Mount 8 N.m (71 lb in)
Knock Sensor Bolt 20 N.m (15 lb ft)
Manifold Absolute Pressure Sensor Bolt 6 N.m (53 lb in)
Multiport Fuel Injection Fuel Rail Bolt 8 N.m (71 lb in)
Oil Filter Cap 25 N.m (18 lb ft)
Oil Flow Check Valve Bore Plug 21 N.m (15 lb ft)
Oil Pan Baffle Bolt 10 N.m (89 lb in)
Oil Pan Bolt 10 N.m (89 lb in)
Oil Pan Drain Plug 14 N.m (124 lb in)
Oil Pan Transmission Housing Bolt M10 (Automatic Transmission) 40 N.m (30 lb ft)
Oil Pan Transmission Housing Bolt M12 (Automatic Transmission) 60 N.m (44 lb ft)
Oil Pan Transmission Housing Bolt (Manual Transmission) 60 N.m (44 lb ft)
Oil Pan Transmission Housing Nut 40 N.m (30 lb ft)
Oil Pressure Relief Valve Closure Bolt 21 N.m (15 lb ft)
Spark Plug 25 N.m (18 lb ft)
Throttle Body Bolt 8 N.m (71 lb in)
Timing Belt Lower Front Cover Bolt 6 N.m (53 lb in)
Timing Belt Upper Front Cover Bolt 6 N.m (53 lb in)
scientia non olet · About LEMON Manuals