Circuit/System Verification
- Ignition ON.
- Verify that DTC B1405 is not set.
- If the DTC is set
Refer to DTC B1405
- If the DTC is not set
- If the DTC is set
- Verify that DTC B0958 01, B0960 01, B0961 01, B096C 01 or B096D 21 is not set.
- If the DTC is set
- Verify the B306 Parking Assist Sensors are not contaminated with snow, mud, dirt, slush, or ice.
- If contaminated, clean the B306 Parking Assist Sensors.
- If there is no contamination
- Refer to Circuit/System Testing .
- If the DTC is not set
- Verify that DTC B0958 3A, B0960 3A, B0961 3A, B096C 3A or B096D 3A is not set.
- If the DTC is set
Replace the appropriate B306 Parking Assist Sensor with the correct sensor type.
- If the DTC is not set
- If the DTC is set
- Ignition ON, transmission in R.
- Verify the scan tool Parking Assist System Status parameter is Enabled.
- If the parameter is Disabled
Refer to Circuit/System Testing .
- If the parameter is Enabled
- If the parameter is Disabled
- All OK.