Installation Procedure
WARNING: This page is about a different car, the 2016 GMC Sierra 1500 and 2016 Chevrolet Silverado 1500. However, it is still accessible from the selected car via links, so may be relevant.
- Generator Control Module - Install
- Generator Control Module Mounting Nut - Install and tighten 22 (16 lb ft)
- Generator Control Module Coolant Outlet Hose @ Generator Control Module - Engage - Generator Control Module Coolant Outlet Hose Replacement (Starter Generator to Generator Control Module L8B)Generator Control Module Coolant Outlet Hose Replacement (Starter Generator to Drive Motor Battery Surge Tank Inlet Hose L8B)
- Generator Control Module Coolant Tank Hose @ Generator Control Module - Engage - Generator Control Module Coolant Tank Hose Replacement (Bottom L8B)Generator Control Module Coolant Tank Hose Replacement (Low Temp Radiator to Generator Control Module L8B)
- Battery Positive Junction Block Cable - Install
- Battery Positive Junction Block Cable Nut - Install and tighten 9 (80 lb in)
- Battery Distribution Engine Compartment Fuse Block Nut - Install and tighten 15 (11 lb ft)
- Fuse Block Cover - Install
- High Voltage Battery Pack Positive Cable Connector - Connect
- Starter Generator High Voltage Cable Connector - Connect
- Electrical Connector - Connect
- Ground Terminal Fastener - Install and tighten 9 (80 lb in)
- Front End Sheet Metal Diagonal Brace - Install
- Retainer Clip - Engage
- Front End Sheet Metal Diagonal Brace Bolt - Install and tighten 25 (18 lb ft)
- Enable the high voltage system. High Voltage Enabling
CAUTION:
Refer to Fastener Caution