Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON / Vehicle in Service Mode.
- Verify the scan tool Brake Pedal Applied parameter changes from Inactive to Active when the brake pedal is applied.
- If the parameter does not change
Refer to Stop Lamps Malfunction
- If the parameter changes
- If the parameter does not change
- Verify the S3 Transmission Shift Lever moves out of the PARK position when the brake pedal is applied.
- If the S3 Transmission Shift Lever does not move out of the PARK position
Refer to Circuit/System Testing.
- If the S3 Transmission Shift Lever does move out of the PARK position
All OK.
- If the S3 Transmission Shift Lever does not move out of the PARK position