Fastener Specifications
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Center Bearing Slinger |
| Dust Boot at Propeller Shaft Front Section Clamp |
| Propeller Shaft Center Bearing Retaining Circlip |
| Propeller Shaft Dust Boot |
| Spline Retention O-Ring |
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Propeller Shaft Coupling at Transmission Flange Bolt | |
| Torque Prevailing Nut at Transmission Flange | |
| First Pass: | 90 N.m (66 lb ft) |
| Final Pass: | 52.5 degrees |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Propeller Shaft Center Support Bearing at Body Retaining Bolt | 22 N.m (16 lb ft) |
| Propeller Shaft Coupling at Differential Flange Retaining Bolt | |
| First Pass: | 90 N.m (66 lb ft) |
| Final Pass: | 42.5 degrees |