LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> SS Standard Trans >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Object Detection System And Pedestrian Protection System >> Repair Instructions >> Front Parking Assist Alarm Sensor Bracket Replacement (Foglamp Cover)

Front Parking Assist Alarm Sensor Bracket Replacement (Foglamp Cover)

Fig 1: Front Parking Assist Alarm Sensor Bracket (Foglamp Cover)
GM2910564Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Remove the front fog lamp opening cover. Refer to Front Fog Lamp Opening Cover Replacement .
  2. Remove the advanced parking assist alarm sensor. Refer to Advanced Parking Assist Alarm Sensor Replacement .
1 Front Parking Assist Alarm Sensor Bracket

Procedure

  1. Sand/grind sonic weld plastic residue from the fascia.
  2. Apply structural adhesive epoxy, Lord Fusor™ 127EZ or local equivalent, to fascia at mating surface.
  3. Using the alignment tabs, install the sensor bracket to the fascia.
  4. Allow adhesive to cure according to manufacturer's directions.
NOTE:

Do Not grind off alignment tabs.