Removal Procedure
- When major components are removed from the vehicle and the vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to the hoist.
- When performing work in the engine compartment or under the vehicle, ensure that the hood is fully open, or opened to its secondary latch. When the hood is opened to the secondary latch, the vehicle will disable the remote start features from the key fob and OnStar mobile app. Failure to open the hood, or open the hood to the secondary latch while doing a repair in the engine compartment or under the vehicle can result in inadvertent vehicle starting which could result in personal injury or damage to a vehicle.
- Remove the rear wheel. Tire and Wheel Removal and Installation
- Remove the Y-Link to knuckle retaining bolt (1) and nut (2).
Discard the nut.
- Remove and DISCARD the Y-Link to subframe retaining bolt (3) and nut (4).
- Remove the Y-Link (5).
- Inspect all parts for wear and damage.
WARNING:
To avoid any vehicle damage, serious personal injury or death:
WARNING:
Refer to Safety Glasses Warning
NOTE:
Mark the location of the bolt and nut relative to the Y-Link for correct re-assembly.
NOTE:
Prevailing torque nuts must be discarded after removal.