LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> SS Automatic Trans >> Repair and Diagnosis (Single Page) >> Body & Frame >> Ignition Switch/Steering Lock >> Diagnostic Information And Procedures >> Diagnostic Information and Procedures >> DTC B097C: Power Mode Run/Start Indicator Circuit >> Component Testing

Component Testing

  1. Ignition OFF, disconnect the harness at the S38 Ignition Mode Switch.
  2. Connect a jumper wire between the S38 Ignition Mode Switch terminal 4 and ground.
  3. Connect a 3 A fused jumper wire between the S38 Ignition Mode Switch terminal 5 and B+.
  4. Verify the green LED illuminates.
    • If the LED does not illuminate 

      Replace the S38 Ignition Mode Switch.

    • If the LED illuminates 
  5. Connect a 3 A fused jumper wire between the S38 Ignition Mode Switch terminal 2 and B+.
  6. Verify the amber LED illuminates.
    • If the LED does not illuminate 

      Replace the S38 Ignition Mode Switch.

    • If the LED illuminates 
  7. All OK.
scientia non olet · About LEMON Manuals