LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> SS Automatic Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Object Detection System And Pedestrian Protection System >> Diagnostic Information and Procedures >> Rear Vision Camera System Malfunction >> Circuit/System Verification

Circuit/System Verification

NOTE:

If the condition is intermittent or cannot be duplicated, disconnect the connectors and add Nyogel lubricant 760G. This procedure will correct the high resistance condition due to terminal fretting corrosion.

  1. Ignition ON.
  2. Verify that DTC B2545 is not set.
    • If the DTC is not set 
  3. Verify the rearview camera there is no debris on the lens and that the bezel or bezel seal is not damaged.
    • If debris are found on the lens 

      Clean the lens. If the lens, bezel, or bezel seal are damaged, replace as necessary.

    • If no debris on the lens 
  4. Ignition ON, transmission in REVERSE.
  5. Verify the backup lamps are On.
    • If the backup lamps are ON 
  6. Engine running, transmission in REVERSE.
  7. Verify a clear rear vision image is displayed on the radio.
    • If a clear image is not displayed 

      Refer to Circuit/System Testing.

    • If a clear image is displayed 
  8. All OK.
scientia non olet · About LEMON Manuals