LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Cruze LT, 4D Hatchback, Automatic Trans >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Current Sensor Replacement >> Removal Procedure

Removal Procedure

  1. Record all of the radio station presets.
  2. Ensure that all lamps and accessories are turned off.
  3. Turn the ignition OFF and remove the ignition key.
  4. Open the rear compartment lid.
  5. Remove Rear Compartment Floor Panel Trim Replacement (Notchback)Rear Compartment Floor Panel Trim Replacement (Hatchback)
  6. Remove Rear Compartment Floor Panel Trim Support Replacement
  7. Open the right rear door.
  8. Fold the rear seat back cushion forward to get a better access to the battery.
  9. Disconnect Battery Negative Cable Disconnection and Connection 
    10. Fig 1: Battery Negative Pole Clamp And Nut
    GM4091388Courtesy of GENERAL MOTORS COMPANY
  10. Loosen the battery negative pole clamp nut (2).
  11. Disconnect the battery negative pole clamp (1).
    12. Fig 2: Body Extension Current Sensor Wiring Harness To Battery Negative Cable Bolt
    GM4091410Courtesy of GENERAL MOTORS COMPANY
  12. Remove body extension current sensor wiring harness to battery negative cable bolt (1).
    13. Fig 3: Battery Current Sensor Connector
    GM4091389Courtesy of GENERAL MOTORS COMPANY
  13. Disconnect the battery current sensor connector.(2)
  14. Unclip Battery Negative Cable Clip (1)
    15. Fig 4: Battery Negative Cable Terminal Cover And Battery Current Sensor
    GM4091391Courtesy of GENERAL MOTORS COMPANY
  15. Remove the battery negative cable terminal cover (1).
  16. Remove Battery Current Sensor (2)
scientia non olet · About LEMON Manuals