LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Cruze L >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Negative Cable Replacement >> Removal Procedure

Removal Procedure

  1. Record all of the radio station presets.
  2. Ensure that all lamps and accessories are turned off.
  3. Turn the ignition OFF and remove the ignition key.
  4. Open the rear compartment lid.
  5. Remove Rear Compartment Floor Panel Trim Replacement (Notchback)Rear Compartment Floor Panel Trim Replacement (Hatchback)
  6. Remove Rear Compartment Floor Panel Trim Support Replacement
  7. Open the right rear door.
  8. Fold the rear seat back cushion forward to get a better access to the battery.
  9. Disconnect Battery Negative Cable Disconnection and Connection 
  10. With start/stop system use the following steps:
      Fig 1: Battery Negative Cable Nut
      GM4091412Courtesy of GENERAL MOTORS COMPANY
      NOTE:

      Use a counterholder to prevent the battery sensor from damage.

    1. Install a open-end spanner (1) to counter-hold the battery sensor as shown in the graphic.
    2. Remove the battery negative cable nut (2).
    3. Disconnect Battery Negative Cable (3)
      4. Fig 2: Battery Negative Cable Clips
      GM4091413Courtesy of GENERAL MOTORS COMPANY
    4. Unclip Battery Negative Cable Clip (1)
  11. Without start/stop system use the following steps:
      Fig 3: Battery Negative Pole Clamp And Nut
      GM4091388Courtesy of GENERAL MOTORS COMPANY
    1. Loosen the battery negative pole clamp nut (2).
    2. Disconnect the battery negative pole clamp (1).
      3. Fig 4: Body Extension Current Sensor Wiring Harness To Battery Negative Cable Bolt
      GM4091410Courtesy of GENERAL MOTORS COMPANY
    3. Remove body extension current sensor wiring harness to battery negative cable bolt (1).
      4. Fig 5: Battery Current Sensor Connector
      GM4091389Courtesy of GENERAL MOTORS COMPANY
    4. Disconnect the battery current sensor connector.(2)
    5. Unclip Battery Negative Cable Clip (1)
      6. Fig 6: Battery Negative Cable Terminal Cover And Battery Current Sensor
      GM4091391Courtesy of GENERAL MOTORS COMPANY
    6. Remove the battery negative cable terminal cover (1).
    7. Remove Battery Current Sensor (2)
scientia non olet · About LEMON Manuals