LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Corvette Z06, 2D Convertible, Standard Trans >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Steering Gear Boot Replacement >> Installation Procedure

Installation Procedure

    Fig 1: NEW Steering Gear Boot Inner Clamp
    GM3417807Courtesy of GENERAL MOTORS COMPANY
  1. Position a NEW steering gear boot inner clamp (1) loosely on the steering gear boot (2).
  2. Position the steering gear boot (2) on the steering gear.
  3. Partially lower the vehicle.
  4. From the engine compartment, use the CH-22610  pliers to tighten the NEW steering gear boot inner clamp (1).
  5. Raise the vehicle.
    6. Fig 2: Steering Linkage Inner Tie Rod Nut
    GM3417806Courtesy of GENERAL MOTORS COMPANY
  6. Install Steering Gear Boot Outer Clamp (2)
  7. Install Steering Linkage Inner Tie Rod Nut (1)
  8. Install Steering Linkage Outer Tie Rod - Steering Linkage Outer Tie Rod Replacement 
  9. If servicing the right side steering gear boot, install the air cleaner assembly. Air Cleaner Assembly Replacement (LT1)Air Cleaner Assembly Replacement (LT4)
  10. If servicing the left side steering gear boot, install the air cleaner outlet duct. Air Cleaner Outlet Duct Replacement (LT1)Air Cleaner Outlet Duct Replacement (LT4)
scientia non olet · About LEMON Manuals