LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Corvette Z06, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Exhaust System >> Repair Instructions >> Intermediate Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING:

Refer to Exhaust Service Warning .

WARNING:

Refer to Protective Goggles and Glove Warning .

  1. Raise and properly support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the floor panel tunnel panel reinforcement. Refer to Floor Panel Tunnel Panel Reinforcement Replacement .
  3. Install a jack stand under the intermediate pipe.
    4. Fig 1: Exhaust Pipe/Muffler Band Clamps
    GM3356901Courtesy of GENERAL MOTORS COMPANY
  4. Loosen the exhaust muffler band clamps (1).
    5. Fig 2: Intermediate Pipe-To-Catalytic Converter Pipe Fasteners And Exhaust Pipe Seals
    GM3356917Courtesy of GENERAL MOTORS COMPANY
  5. Remove the intermediate pipe-to-catalytic converter pipe fasteners (1) and DISCARD the exhaust pipe seals.
    6. Fig 3: Fasteners And Intermediate Pipe Hanger
    GM3356984Courtesy of GENERAL MOTORS COMPANY
  6. Remove the fasteners (1) securing the intermediate pipe hanger (2) to the vehicle.
  7. Separate the intermediate pipe (3) from the exhaust mufflers.
  8. Lower the jack stand with the intermediate pipe.
  9. If replacing the intermediate pipe, remove the hanger bracket assembly and transfer to new part.
scientia non olet · About LEMON Manuals