LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Camaro ZL1, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> Steering >> Steering Wheel And Steering Column >> Repair Instructions >> Intermediate Steering Shaft Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Intermediate Steering Shaft
    GM4212775Courtesy of GENERAL MOTORS COMPANY
  1. Position the intermediate steering shaft (1) on the vehicle.
    2. Fig 2: Intermediate Steering Shaft Upper Bolt And Intermediate Steering Shaft Lower Bolt
    GM4212774Courtesy of GENERAL MOTORS COMPANY
  2. UNLOCK and turn the steering wheel so the intermediate steering shaft upper bolt (1) and intermediate steering shaft lower bolt (2) can be installed.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install and tighten Intermediate Steering Shaft Lower Bolt (2) to 50 N.m (37 lb ft)
    1. Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
    2. Apply thread locking adhesive to the bolt. Refer to Adhesives, Fluids, Lubricants, and Sealers 
  4. Install and tighten Intermediate Steering Shaft Upper Bolt (1) to 36 N.m (27 lb ft)
    1. Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
    2. Apply thread locking adhesive to the bolt. Refer to Adhesives, Fluids, Lubricants, and Sealers 
  5. Inspect the Cardan joint boot for proper positioning.

    The boot MUST be pulled downwards to the original position, or such that the end of the boot is directly adjacent to the intermediate steering shaft lower bolt.

scientia non olet · About LEMON Manuals