LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Camaro ZL1, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 6.2L (LT1 LT4) - Repair Instructions >> Repair Instructions >> Camshaft Position Sensor Replacement (LT4) >> Installation Procedure

Installation Procedure

    Fig 1: Camshaft Position Sensor And Seal
    GM4212006Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    If a new sensor is not being installed, inspect the camshaft sensor seal (2) and replace as needed.

  1. Install the camshaft position sensor (1) into the engine front cover.
    2. Fig 2: Camshaft Position Sensor Bracket And Sensor Wiring Harness
    GM4211991Courtesy of GENERAL MOTORS COMPANY
  2. Position the camshaft position sensor bracket (1) in place.
    3. Fig 3: Engine Wiring Harness Connectors
    GM4211962Courtesy of GENERAL MOTORS COMPANY
  3. Connect the and the engine wiring harness connector (1), oil pump flow control valve connector (2), camshaft position actuator solenoid connector (3), camshaft position sensor connector (4).
    4. Fig 4: Camshaft Position Sensor Bracket Fasteners
    GM4211965Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  4. Install the camshaft position sensor bracket fasteners (1) and tighten to 25 N.m (18 lb ft).
  5. Install Air Conditioning Compressor Belt. Refer to Air Conditioning Compressor Belt Replacement
  6. Install Air Cleaner Outlet Duct. Refer to Air Cleaner Outlet Duct Replacement (LT4) 
scientia non olet · About LEMON Manuals