Installation Procedure

Fig 1: Wheel Stud, Flat Washers And Wheel Nut

Courtesy of GENERAL MOTORS COMPANY

Position the NEW wheel stud (1) in the flange on the hub assembly.
Install the CH-45101-100 conical brake rotor washers or flat washers (2) and an OLD wheel nut (3) on the wheel stud.
Use a suitable tool to prevent the flange on the hub assembly from rotating.
Tighten the wheel nut until the wheel stud is firmly seated.
Remove the wheel nut and flat washers.
Install Front Wheel Bearing and Hub Assembly. Refer to Front Wheel Bearing and Hub Replacement