Common Specs & Procedures Index
VOLT - COMMON SPECS & PROCEDURES
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | APPROXIMATE FLUID CAPACITIES | ||
| Torque | FASTENER SPECIFICATIONS | ||
| Axle Nut/Hub Nut | |||
| First Pass | 150 N.m (111 lb ft) | ||
| Second Pass | Loosen 45 degrees | ||
| Final Pass | 250 N.m (184 lb ft) | ||
| Battery | NA | ||
| Brakes | |||
| Bleeding Sequence | RIGHT REAR, LEFT REAR, RIGHT FRONT, LEFT FRONT HYDRAULIC BRAKE SYSTEM BLEEDING |
||
| Disc Brakes | |||
| Service Specifications | DISC BRAKE COMPONENT SPECIFICATIONS | ||
| Torque | FASTENER SPECIFICATIONS | ||
| Charging | |||
| Generator | N/A | ||
| Torque | FASTENER SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | Serpentine Belt Used, Not Adjustable | ||
| Drive Belt Routing | N/A | ||
| Engine Cooling | |||
| General Service Specifications | N/A | ||
| Radiator Cap Pressure | Pressure Stamped on Cap | ||
| Thermostat R & I | |||
| 1.5L | N/A | ||
| Water Pump R & I | |||
| 1.5L | WATER PUMP REPLACEMENT | ||
| Engine Mechanical | |||
| 1.5L | |||
| Compression | ENGINE COMPRESSION TEST | ||
| Oil Pressure - @ 1500 RPM 100°C | 200-250 kPa (29-36 psi) | ||
| Overhaul | ENGINE MECHANICAL SPECIFICATIONS | ||
| Torque | FASTENER SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE/FLUIDS tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate/Drive Plate Torque | First Pass - 30 N.m (22 lb ft) Final Pass - Additional 70° |
||
| Fuel System | |||
| Pressure Specification | Engine OFF, Pump Commanded ON - 345-650 kPa (50-94 psi) Engine ON Running - 379-427 kPa (55-62 psi) On Scan Tool |
||
| Fuel Pressure Test Procedure | CIRCUIT/SYSTEM VERIFICATION | ||
| Fuel Filter Location | Fuel Filter is Part of the Fuel Tank Fuel Pump Module | ||
| Fuel Filter R & I | FUEL TANK FUEL PUMP MODULE REPLACEMENT | ||
| Ignition | |||
| Firing Order & Cylinder Identification | See FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | Individual Ignition Coil Module | ||
| Ignition Wires (Routing) | |||
| 1.5L | Coil on Plug | ||
| Spark Plug (Type = Refer to Electronic Parts Catalog) | |||
| Gap | 0.70 mm (0.028 in) | ||
| Torque | 17 N.m (13 lb ft) | ||
| Starting | |||
| Starter | N/A | ||
| Torque | FASTENER SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | FASTENER SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 140 N.m (103 lb ft) For wheel nut tightening sequence (star pattern), see illustration under tire and wheel INSTALLATION PROCEDURE |
||