LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2016 >> Volt Premier >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 1.5L (L3A) - Repair Instructions >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Manifold Absolute Pressure Sensor, Electrical Connector, Bolt And Seal Ring
    GM4091405Courtesy of GENERAL MOTORS COMPANY
  1. Install Seal Ring (4)
  2. Install Manifold Absolute Pressure Sensor (3)
    3. CAUTION:

    Refer to Fastener Caution

  3. Install and tighten Manifold Absolute Pressure Sensor Bolt (2) to 10 N.m (89 lb in)
  4. Connect the electrical connector (1).
    5. Fig 2: Fuel Feed Front Pipe And Fuel Injection Pump
    GM4091024Courtesy of GENERAL MOTORS COMPANY
  5. Install Fuel Feed Front Pipe (2)
  6. Remove all EN-6015  plugs from the connections.
  7. Connect Fuel Feed Front Pipe (2) @ Fuel Injection Pump (1)
    8. Fig 3: Air Cleaner Resonator Bracket, Bolt And Wiring Harness Clip
    GM4091051Courtesy of GENERAL MOTORS COMPANY
  8. Install Air Cleaner Resonator Bracket (2)
  9. Install and tighten Air Cleaner Resonator Bracket Bolt (1) to 9 N.m (80 lb in)
  10. Install Wiring Harness Clip (3)
  11. Install Air Inlet Grille Panel. Refer to Air Inlet Grille Panel Replacement
  12. Install Intake Manifold Cover. Refer to Intake Manifold Cover Replacement
  13. Install Air Cleaner Outlet Duct. Refer to Air Cleaner Outlet Duct Replacement 
  14. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection
scientia non olet · About LEMON Manuals