LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2016 >> Trax LS, AWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Starter Replacement (LE2-AWD) >> Installation Procedure

Installation Procedure

    Fig 1: Starter
    GM4111083Courtesy of GENERAL MOTORS COMPANY
  1. Starter (3) - Install
    2. CAUTION:

    Refer to Fastener Caution

  2. Starter Mounting Bolt (2)Install and tighten 58 N.m (43 lb ft)
  3. Starter Mounting Nut (1) Install and tighten 58 N.m (43 lb ft)
    4. Fig 2: Engine Coolant Heater Cord
    GM4111076Courtesy of GENERAL MOTORS COMPANY
  4. { If equipped }Engine Coolant Heater Cord (2) - Connect
  5. Battery Positive Cable (4) - Install
  6. Starter Solenoid Cable Nut (3)Install and tighten 12.5 N.m (111 lb in)
  7. Electrical Connector (1) - Connect
  8. Transfer Case Replacement - Install
  9. Lower the vehicle.
  10. Connect the negative battery cable. Battery Negative Cable Disconnection and Connection (without KL9) Battery Negative Cable Disconnection and Connection (with KL9) 
scientia non olet · About LEMON Manuals