LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2016 >> Trax LS, AWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Sensor Replacement (KL9) >> Installation Procedure

Installation Procedure

    Fig 1: Battery Sensor Module
    GM4098031Courtesy of GENERAL MOTORS COMPANY
  1. Battery Sensor Module (2) - Install
  2. Battery Negative Post Clamp Nut (1) - Tighten 4.5 N.m (40 lb in)
    3. Fig 2: Battery Negative Cable
    GM4098029Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  3. Use an open ended wrench to hold the battery sensor ground tab, while tightening the battery negative cable nut.
  4. Battery Negative Cable (1) - Install
  5. Battery Negative Cable Nut (3) - Install and tighten 11 N.m (97 lb in)
    6. Fig 3: Battery Sensor Electrical Connector
    GM4098026Courtesy of GENERAL MOTORS COMPANY
  6. Connect the electrical connector. (1)
    7. NOTE:

    Inform the customer that the Stop/Start feature will not be available until the vehicle is allowed to sit for at least 3 hours undisturbed. If diagnosing a stop/start complaint, conduct the battery sensor module learn procedure to verify the repair.

  7. Perform a re-learn procedure on the battery sensor module, refer to Battery Sensor Module Learn 
scientia non olet · About LEMON Manuals