LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2016 >> Traverse LS, AWD >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Drive Axle >> Repair Instructions >> Differential Replacement >> Removal Procedure

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tires and wheels. Refer to Tire and Wheel Removal and Installation .
  3. Drain the rear differential assembly. Refer to Axle Lubricant Change .
  4. Remove the rear wheel drive shafts. Refer to Rear Wheel Drive Shaft and Rear Axle Shaft Seal Replacement .
  5. Remove the propeller shaft assembly. Refer to Propeller Shaft Replacement .
    6. Fig 1: Torque Tube Mounting Bolt
    GM1848880Courtesy of GENERAL MOTORS COMPANY
  6. Remove the front torque tube mounting bracket bolt.
    7. Fig 2: Torque Tube
    GM1848899Courtesy of GENERAL MOTORS COMPANY
  7. Lower the front of the torque tube to gain access to the electronic clutch control module.
    8. Fig 3: Clutch Control Module Electrical Connector
    GM1848839Courtesy of GENERAL MOTORS COMPANY
  8. Disconnect the electrical connector from the electronic clutch control module.
  9. Support the torque tube with a jack stand.
  10. Support the rear differential assembly with a transmission jack.
    11. Fig 4: Rear Differential Drive Mounting Bolts
    GM1848862Courtesy of GENERAL MOTORS COMPANY
  11. Remove the rear differential drive mounting bolts.
    12. Fig 5: Rear Differential Assembly
    GM1848893Courtesy of GENERAL MOTORS COMPANY
  12. With the aide of an assistant, remove the rear differential assembly from the vehicle.
  13. Remove the torque tube assembly mounting bolts from the rear differential assembly. Refer to Driveline Torque Tube Replacement .
scientia non olet · About LEMON Manuals