LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2016 >> Spark LS, Standard Trans >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Positive Cable Replacement >> Removal Procedure

Removal Procedure

  1. Disconnect the negative battery cable. Battery Negative Cable Disconnection and Connection .
  2. Remove the engine control module (S53) from the battery tray. Engine Control Module Replacement
    3. Fig 1: Battery Positive Cable Terminal Cover
    GM4087645Courtesy of GENERAL MOTORS COMPANY
  3. Open the battery positive cable terminal cover (2).
  4. Remove the engine wiring harness junction block cover (1).
    5. Fig 2: Body Wiring Harness Connectors
    GM4087647Courtesy of GENERAL MOTORS COMPANY
  5. Disconnect the body wiring harness connectors (1) and remove the body wiring harness (2) from the battery positive cable junction block.
    6. Fig 3: Battery Positive Cable Junction Block Post Nut
    GM4087640Courtesy of GENERAL MOTORS COMPANY
  6. Loosen the battery positive cable junction block post nut (1).
  7. Remove the engine wiring harness junction block nut (2).
  8. Remove the battery positive cable (3) from the battery and the engine wiring harness junction block.
    9. Fig 4: Battery Positive Cable Retainers And Battery Positive Cable
    GM4009338Courtesy of GENERAL MOTORS COMPANY
  9. Remove the battery positive cable retainers (1) and remove the battery positive cable (2) from the battery tray.
  10. Remove the battery. Battery Replacement .
    11. Fig 5: Battery Negative And Positive Ground Nut
    GM4009339Courtesy of GENERAL MOTORS COMPANY
  11. Remove the battery negative and positive ground nut (1) and remove the battery positive cable (2) from the frame stud ground.
    12. Fig 6: Battery Positive Cable Nut, Bolt And Protective Cover
    GM4009340Courtesy of GENERAL MOTORS COMPANY
  12. Remove the battery positive cable nut (1) from the starter solenoid.
  13. Remove the battery positive cable ground bolt (4).
  14. Remove the protective cover (3) at the back of the generator.
  15. Remove the generator B (+) nut (2) from the generator B+ Stud.
  16. Remove the battery positive cable (5).
scientia non olet · About LEMON Manuals