LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2016 >> Spark LS, Automatic CVT Trans >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraint System >> Repair Instructions >> Airbag Instrument Panel Module Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Passenger Air Bag Module
    GM4237255Courtesy of GENERAL MOTORS COMPANY
    WARNING:

    Never install the passenger airbag module into the instrument panel assembly that airbag module chute is cut. This may cause incorrect deployment when the passenger airbag is deployed.

  1. Position the passenger air bag module (1) on the air bag bracket.
    2. CAUTION:

    Make sure that the passenger airbag is installed into the chute completely.

  2. Push the passenger airbag module (1) into the airbag bracket until the hooks of airbag module is seated completely.
    3. Fig 2: Instrument Panel Inflatable Restraint Module Bolts
    GM4237241Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  3. Install the passenger air bag module bolts (1) and tighten to 10 N.m (89 lb in)
  4. Install the windshield defroster nozzle. Refer to Windshield Defroster Nozzle Replacement .
  5. Install the instrument panel outer air outlet duct. Refer to Instrument Panel Outer Air Outlet Duct Replacement .
  6. Install the instrument panel upper trim panel. Refer to Instrument Panel Upper Trim Panel Replacement .
  7. Enable the SIR system. Refer to SIR Disabling and Enabling .
  8. After replacing the module, fully deploy the old module before disposal. Refer to Inflatable Restraint Module Handling and Scrapping .
scientia non olet · About LEMON Manuals