LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2016 >> SS Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Shift Lock Control System) >> Diagnostic Information and Procedures >> Transmission Control Lever Malfunction >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, disconnect the harness connector at the S3 Transmission Shift Lever.
  2. Install a 3 A fused jumper wire between the control terminal 4 and 12 V. Momentarily install a jumper wire between the ground terminal 2 and ground.
  3. Verify the M7 Transmission Shift Lock Control Solenoid Actuator turns on & off/clicks, etc.
    • If the M7 Transmission Shift Lock Control Solenoid Actuator does not turn on & off/clicks, etc 

      Replace the S3 Transmission Shift Lever.

    • If the M7 Transmission Shift Lock Control Solenoid Actuator does turn on & off/clicks, etc 
  4. All OK
scientia non olet · About LEMON Manuals