Rear Toe Adjustment
- Measure the alignment angles and record the readings. Wheel Alignment Measurement .
- Remove Rear Suspension Adjust Link Nut (1) - Adjust Link Replacement
- Remove Rear Suspension Adjust Link Inner Bolt - Adjust Link Replacement
- Install Rear Suspension Adjust Link Inner Bolt - Adjust Link Replacement
- Install Rear Suspension Adjust Link Nut (1) - Adjust Link Replacement Do not fully tighten at this time.
- Rotate the rear suspension adjust link inner bolt (1) until the proper toe measurement is achieved. Wheel Alignment Specifications .
- Hold the rear suspension adjust link inner bolt and tighten the rear suspension adjust link nut (1). Adjust Link Replacement
- Check the alignment specification and readjust if necessary. Wheel Alignment Specifications
NOTE:
Tighten the rear suspension adjust link nut enough to maintain the adjustment. Verify the rear toe reading prior to tightening the bolt to its final torque.
CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.
CAUTION:
Refer to Fastener Caution .