Rear Camber Adjustment
- Remove Rear Suspension Lower Control Arm Inner Nut (1) - Lower Control Arm Replacement
- Remove Rear Suspension Lower Control Arm Adjust Bolt (1) - Lower Control Arm Replacement
- Install Rear Suspension Lower Control Arm Adjust Bolt - Lower Control Arm Replacement
- Install Rear Suspension Lower Control Arm Inner Nut - Lower Control Arm Replacement Do not fully tighten at this time.
- Rotate the rear suspension lower control arm adjust bolt (1) until the correct camber measurement is achieved. Wheel Alignment Measurement
- Hold the rear suspension control arm adjust bolt and tighten the rear suspension upper inner nut (1). Lower Control Arm Replacement
- Check the alignment specification and readjust if necessary. Wheel Alignment Specifications
NOTE:
Tighten the nut and bolt enough to maintain the adjustment. Verify the camber reading prior to tightening the bolt to its final torque.
CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.
CAUTION:
Refer to Fastener Caution .