Rear Toe Adjustment
WARNING: This page is about a different car, the 2016 Chevrolet Malibu Limited. However, it is still accessible from the selected car via links, so may be relevant.
- Verify the alignment on an alignment rack. Refer to Wheel Alignment Measurement
- Remove and DISCARD the control arm bolt (1).CAUTION: This bolt is designed to permanently stretch when tightened and therefore MUST be replaced anytime it is removed. The correct part number fastener must be used to replace this type of fastener. Do not use a bolt that is stronger in this application. If the correct bolt is not used, the parts will not be tightened correctly. The system or the components may be damaged.
- Install the NEW control arm bolt (1).
- Rotate the rear suspension link inner nut (2) in order to adjust the toe angle. Refer to Wheel Alignment Measurement
- Hand tighten the rear suspension link inner nut (1), but do not tighten the nut (2) to the specification yet.NOTE: Do not tighten the NEW bolts. Leave the NEW bolts loose to allow for adjustment.
- Verify the rear toe angle and adjust as necessary.
- Tighten the rear suspension link inner nut. Refer to Adjust Link ReplacementCAUTION: Refer to Fastener Caution .NOTE: Hold the suspension bolt so as not to allow it to rotate in either direction.
- Lower the vehicle.