Installation Procedure

Position the front suspension strut assembly (1) on the vehicle.

Fig 1: Front Suspension Strut Assembly
Courtesy of GENERAL MOTORS COMPANY
Front Suspension Strut Mount Bolt (1)» Install [3x]

Fig 2: Front Suspension Strut Mount Bolt
Courtesy of GENERAL MOTORS COMPANY

CAUTION: This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.

Install NEW bolts.
Use the EN-45059 meter to tighten the front suspension strut mount bolts. (1)
CAUTION: Refer to Fastener Caution .

Tighten
1. First Pass: 22 N.m (16 lb ft)
2. Final Pass: (30-45 degrees)
Install the plugs that cover the front suspension strut mount fasteners. (1)

Fig 3: Front Suspension Strut Mount Fasteners
Courtesy of GENERAL MOTORS COMPANY
Steering Knuckle Bolt (2)» Install [2x]

Fig 4: Steering Knuckle Nuts And Bolts
Courtesy of GENERAL MOTORS COMPANY

Install NEW bolts.
Steering Knuckle Nut (1)» Install [2x]
Use the EN-45059 meter to tighten the steering knuckle nuts. (1)
Tighten
1. First Pass: 100 N.m (74 lb ft)
2. Final Pass: (45-60 degrees)
Front Stabilizer Shaft Link (1) @ Strut Assembly» Install - Stabilizer Shaft Link Replacement

Fig 5: Front Stabilizer Shaft Link
Courtesy of GENERAL MOTORS COMPANY
Front Wheel Speed Sensor Grommet (1) @ Strut Assembly» Install - Front Wheel Speed Sensor Replacement

Fig 6: Front Wheel Speed Sensor Grommet
Courtesy of GENERAL MOTORS COMPANY
Air Inlet Grille Panel» Install - Air Inlet Grille Panel Replacement
Measure and adjust the wheel alignment. Refer to Wheel Alignment Measurement