Removal Procedure
WARNING: This page is about a different car, the 2016 Chevrolet Malibu Limited. However, it is still accessible from the selected car via links, so may be relevant.
- Open the rear compartment lid in order to access the reveal molding.WARNING: If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.NOTE: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
- Disconnect the rear window defogger electrical connectors.
- Disconnect the rear window radio antenna.
- Cover to protect the following parts from broken glass:WARNING: If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.
- Upper dash pad
- Defroster outlets and A/C outlets
- Seats and carpeting
- This will allow the urethane adhesive to be separated from the window.NOTE: Keep the cutting edge of the tool against the window. There are window locating pins, one in each corner of the window. Use care Not to remove or cut them off when removing the window. If the window locator pins are cut, it will be necessary to tape the window in place.
- Leave a base of urethane on the pinchweld flange.
- The only suitable lubrication is clean water.
- BO-39032 Stationary Glass Removal Tool or equivalent in order to remove the window.
- Remove the rear window (1) with an assistant (2) from the vehicle.