Replace and Program Control Module or Reprogram Control Module

WARNING: This page is about a different car, the 2015 Chevrolet Caprice. However, it is still accessible from the selected car via links, so may be relevant.

To program a replacement or an existing control module, perform the following procedure:

Install EL-49642 SPS Programming Support Tool.
Access the Service Programming System (SPS) and follow the on-screen instructions.

NOTE:

The Prepare Control Module for Removal function can only be performed when communication with the old control module is still possible.

Before removing the old control module, perform the SPS function Prepare Control Module for Removal, if available.
On the SPS Supported Controllers screen, select K17 Electronic Brake Control Module - Programming and follow the on-screen instructions.
On the SPS Supported Controllers screen, select K17 Electronic Brake Control Module - Configuration and Setup while following the on-screen instructions.
At the end of programming, choose the "Clear All DTCs" function on the SPS screen.