LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2016 >> Camaro SS, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> Steering >> Steering Wheel And Steering Column >> Repair Instructions >> Mid Intermediate Steering Shaft Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Mid Intermediate Steering Shaft
    GM4199786Courtesy of GENERAL MOTORS COMPANY
  1. Position the mid intermediate steering shaft (1) on the vehicle.
    2. Fig 2: Mid Intermediate Steering Shaft Bolt And Intermediate Steering Shaft Upper Bolt
    GM4199785Courtesy of GENERAL MOTORS COMPANY
  2. UNLOCK and turn the steering wheel so the mid intermediate steering shaft bolt (1) and intermediate steering shaft upper bolt (2) can be installed.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install Intermediate Steering Shaft Upper Bolt (2) and tighten to 36 N.m (27 lb ft)
    1. Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
    2. Apply thread locking adhesive to the bolt. Adhesives, Fluids, Lubricants, and Sealers 
  4. Install Mid Intermediate Steering Shaft Bolt (1) and tighten to 36 N.m (27 lb ft)
    1. Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
    2. Apply thread locking adhesive to the bolt. Adhesives, Fluids, Lubricants, and Sealers 
    5. Fig 3: Two-Piece Boot
    GM4275792Courtesy of GENERAL MOTORS COMPANY
  5. Inspect the two-piece boot (1) on the upper intermediate steering shaft and the connection point of the upper intermediate steering shaft and the mid intermediate steering shaft. Verify the connection point at the two steering shafts is assembled correctly and that the two-piece boot is NOT torn at any point. The two-piece boot is NOT serviceable. If the two-piece boot is torn, the entire upper intermediate steering shaft MUST be replaced.
scientia non olet · About LEMON Manuals