Connect Procedure

Position the battery (1) onto the tray with the posts towards the rear of the vehicle.

Fig 1: Battery
Courtesy of GENERAL MOTORS COMPANY

WARNING: Refer to Battery Disconnect Warning .

NOTE: Clean any existing corrosion from the battery terminal and the battery cable end.
Install the battery hold down retainer (3) and hold down strap (2).

Fig 2: Battery Retainer Bolt
Courtesy of GENERAL MOTORS COMPANY
Tighten the battery retainer bolt (1) to 9 N.m (80 lb in)
CAUTION: Refer to Fastener Caution .
Install the fuse block (3) to the top of the battery with tabs (2).

Fig 3: Battery Positive Clamp Nut And Fuse Block
Courtesy of GENERAL MOTORS COMPANY
Slide the battery clamp (1) onto the battery post and tighten the nut (1) to 4 N.m (35 lb in).
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
Install the rear compartment floor stowage trim compartment. Refer to Rear Compartment Floor Stowage Trim Compartment Replacement