LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Volt >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Infotainment >> Cellular System, Entertainment System And Navigation System >> Diagnostic Information and Procedures >> DTC B2455: Cellular Phone Microphone Circuit (Without UE1) >> Circuit/System Testing

Circuit/System Testing

  1. Vehicle OFF, disconnect the harness connector at the B24 Cellular Phone Microphone, Vehicle in Service Mode.
  2. Test for 9.5-10.5 V between the signal circuit terminal B and ground.
    • If less than 9.5 V 
    1. Vehicle OFF, disconnect the X1 harness connector at the A11 Radio.
    2. Test for infinite resistance between the signal circuit and ground.
      • If less than infinite resistance, repair the short to ground in the circuit.
      • If infinite resistance
    3. Test for less than 2 Ω in the signal circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the A11 Radio.
    • If greater than 10.5 V 
    1. Vehicle OFF, disconnect the X1 harness connector at the A11 Radio, Vehicle in Service Mode.
    2. Test for less than 1 V between the signal circuit and ground.
      • If 1 V or greater, repair the short to voltage on the circuit.
      • If less than 1 V, replace the A11 Radio.
    • If between 9.5-10.5 V 
  3. Ignition ON.
  4. Test for less than 1 V between the signal circuit terminal A and ground.
    • If greater than 1 V 
    1. Vehicle OFF, disconnect the X1 harness connector at the A11 Radio, Vehicle in Service Mode.
    2. Test for less than 1 V between the signal circuit and ground.
      • If 1 V or greater, repair the short to voltage in the circuit.
      • If less than 1 V, replace the A11 Radio.
    • If less than 1 V 
  5. Test for 9.5-10.5 V between the signal circuit terminal B and the signal circuit terminal A.
    • If less than 9.5 V 
    1. Vehicle OFF, disconnect the X1 harness connector at the A11 Radio.
    2. Test for infinite resistance between the signal circuit terminal A and ground.
      • If less than infinite resistance, repair the short to ground in the circuit.
      • If infinite resistance
    3. Test for less than 2 Ω in the signal circuit terminal A end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the vehicle A11 Radio.
    • If greater than 10.5 V 
    1. Vehicle OFF, disconnect the X1 harness connector at the A11 Radio, Vehicle in Service Mode.
    2. Test for less than 1 V between the signal circuit terminal A and ground.
      • If 1 V or greater, repair the short to voltage on the circuit.
      • If less than 1 V, replace the A11 Radio.
    • If between 9.5-10.5 V 
  6. Test or replace the B24 Cellular Phone Microphone.