Front Parking Assist Alarm Sensor Bracket Replacement (Foglamp Cover)

Fig 1: Front Parking Assist Alarm Sensor Bracket (Fog Lamp Cover)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the front fog lamp opening cover. Refer to Front Fog Lamp Opening Cover Replacement . Remove the advanced parking assist alarm sensor. Refer to Advance Parking Assist Alarm Sensor Replacement .
1	Front Parking Assist Alarm Sensor Bracket Procedure Sand/grind sonic weld plastic residue from the fascia. NOTE: Do Not grind off alignment tabs. Apply structural adhesive epoxy, Lord Fusor™ 127EZ or local equivalent, to fascia at mating surface. Using the alignment tabs, install the sensor bracket to the fascia. Allow adhesive to cure according to manufacturer's directions.

Callout

Component Name

Preliminary Procedures
Remove the front fog lamp opening cover. Refer to Front Fog Lamp Opening Cover Replacement .
Remove the advanced parking assist alarm sensor. Refer to Advance Parking Assist Alarm Sensor Replacement .

Front Parking Assist Alarm Sensor Bracket

Procedure

Sand/grind sonic weld plastic residue from the fascia.
NOTE:
Do Not grind off alignment tabs.
Apply structural adhesive epoxy, Lord Fusor™ 127EZ or local equivalent, to fascia at mating surface.
Using the alignment tabs, install the sensor bracket to the fascia.
Allow adhesive to cure according to manufacturer's directions.