LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> SS Automatic Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Object Detection System And Pedestrian Protection System >> Diagnostic Information and Procedures >> Front View Camera Module Malfunction (lane departure warning - UFL) >> Circuit/System Testing

Circuit/System Testing

Lane Departure Warning Switch Malfunction

  1. Ignition OFF, disconnect the harness connector at the S70L Steering Wheel Controls Switch - Left. It may take up to 2 minutes for all vehicle systems to power down.
  2. Test for less than 5 Ω between the S70L Steering Wheel Controls Switch - Left ground circuit terminal 7 and ground.
    • If 5 Ω or greater 
    1. Test for less than 2 Ω in the ground circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, repair the open/high resistance in the ground connection.
    • If less than 5 Ω 
  3. Ignition ON.
  4. Verify the scan tool Lane Departure Warning Switch Status parameter is Open.
    • If not Open 
    1. Ignition OFF. Disconnect the K109 Frontview Camera Module.
    2. Test for infinite resistance between the S70L Steering Wheel Controls Switch - Left signal circuit terminal 2 and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance, replace the K109 Frontview Camera Module.
      • If Open 
  5. Install a 3 A fused jumper wire between the signal circuit terminal 2 and the ground circuit terminal 7.
  6. Verify DTC B356A 02 sets.
    • If DTC does not set 
    1. Ignition OFF, remove the jumper wire, disconnect the harness connector at the K109 Frontview Camera Module, ignition ON.
    2. Test for less than 1 V between the signal circuit and ground.
      • If 1 V or greater, repair the short to voltage on the circuit.
      • If less than 1 V
    3. Test for less than 2 Ω in the signal circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the K109 Frontview Camera Module.
    • If DTC sets 
  7. Test or replace the S70L Steering Wheel Controls Switch - Left.

Lane Departure Warning Switch Indicator Malfunction

  1. Ignition OFF, disconnect the harness connector at the S70L Steering Wheel Controls Switch - Left, ignition ON.
    NOTE:

    Verify interior lighting dimming is turned all the way up.

  2. Test for 6.2-12.0 V between the dimming control circuit terminal 4 and ground.
    • If less than 6.2 V 
    1. Ignition OFF, disconnect the harness connector at the K9 Body Control Module.
    2. Test for infinite resistance between the control circuit and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance
    3. Test for less than 2 Ω in the control circuit end to end.
    • If greater than 12.0 V 
    1. Ignition OFF, disconnect the harness connector at the K9 Body Control Module, ignition ON.
    2. Test for less than 1 V between the control circuit and ground.
    • If between 6.2-12.0 V 
  3. Connect a test lamp between the control circuit terminal 5 and the control voltage circuit terminal 4.
  4. Verify the test lamp turns ON and OFF when commanding the Lane Departure Warning Indicator parameter ON and OFF with a scan tool.
    • If the test lamp is always OFF 
    1. Ignition OFF, disconnect the harness connector at the K109 Frontview Camera Module, ignition ON.
    2. Test for less than 1 V between the control circuit and ground.
      • If 1 V or greater, repair the short to voltage on the circuit.
      • If less than 1 V
    3. Ignition OFF.
    4. Test for less than 2 Ω in the control circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the S70L Steering Wheel Controls Switch - Left.
    • If the test lamp is always ON 
    1. Ignition OFF, disconnect the harness connector at the K109 Frontview Camera Module.
    2. Test for infinite resistance between the control circuit and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance, replace the K109 Frontview Camera Module.
    • If the test lamp turns ON and OFF 
  5. Test or replace the S70L Steering Wheel Controls Switch - Left.
scientia non olet · About LEMON Manuals