LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Impala Limited LS >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front Suspension System >> Repair Instructions >> Steering Knuckle Replacement >> Installation Procedure

Installation Procedure

  1. Install the knuckle to the vehicle.
    2. Fig 1: View Of Steering Knuckle To Strut Bolts
    GM385564Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Install the bolts and nuts attaching the strut to the knuckle.

    Tighten 

    Tighten the strut to knuckle bolts to 130 N.m (96 lb ft).

  3. Install the outer tie rod to the steering knuckle. Refer to Steering Linkage Outer Tie Rod Replacement .
  4. Connect the front lower control arm ball stud to the knuckle. Refer to Lower Control Arm Replacement .
  5. Install the front wheel drive shaft bearing. Refer to Front Wheel Bearing and Hub Replacement .
  6. Lower the vehicle.
  7. Inspect the front wheel alignment and adjust, if necessary. Refer to Wheel Alignment Measurement .
scientia non olet · About LEMON Manuals