Installation Procedure
WARNING: This page is about a different car, the 2015 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
- With the aid of an assistant position the instrument panel (1) to the carrier.
- Reposition the instrument panel wiring harness to the instrument panel as was noted in the removal process and connect the fastener securing the harness to the instrument panel assembly.
- When replacing the instrument panel, transfer all necessary components.
- With the aid of an assistant, install the instrument panel and carrier (1) into the vehicle.
- Install the instrument carrier bolts (3) and tighten to 9 N.m (80 lb in).
Courtesy of GENERAL MOTORS COMPANY
CAUTION: Refer to Fastener Caution . - Install the instrument carrier bolts (2) and tighten.
- Install the front floor console rear air duct retainer (1).
- Install the instrument panel knee bolster (3). Refer to Instrument Panel Knee Bolster Replacement .
- Install the instrument panel compartment (3). Refer to Instrument Panel Compartment Replacement .
- Install the bolts (1) securing the right side of the instrument panel.
- Install the bolt (2) securing the inflatable restraint module to the instrument panel tie bar and tighten to 9 N.m (80 lb in).
- Install the bolts (1) securing the left side of the instrument panel to the instrument carrier.
- Install the instrument cluster (2). Refer to Instrument Cluster Replacement .
- Install the radio control (2). Refer to Radio Control Assembly Replacement .
- Install the radio front center speaker (2). Refer to Radio Front Center Speaker Replacement .
- Install the radio front speaker (2). Refer to Radio Front Speaker Replacement .
- Enable the SIR system. Refer to SIR Disabling and Enabling .