LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Impala Limited LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Parking Brake System) >> Repair Instructions >> Electronic Parking Brake Control Module Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Block the drive wheels.
  2. Disable the parking brake cable adjuster. Refer to Parking Brake Cable Adjuster Disabling 
  3. Place the ignition in the OFF position.
  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  5. Remove the left rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  6. Remove the left rear wheelhouse panel liner. Refer to Rear Wheelhouse Liner Replacement .
  7. Remove the parking brake cable nut (1).
    Fig 1: Parking Brake Cable Nut
    GM2752677Courtesy of GENERAL MOTORS COMPANY
  8. Disconnect the electronic parking brake control module electrical connector.
  9. Remove the electronic parking brake control module nuts (1).
    Fig 2: Electronic Parking Brake Control Module Nuts
    GM2752681Courtesy of GENERAL MOTORS COMPANY
  10. Remove the electronic parking brake control module and bracket assembly.
  11. Remove the electronic parking brake control modulator bracket, if necessary. Refer to Electronic Parking Brake Control Modulator Bracket Replacement .
scientia non olet · About LEMON Manuals