Rear Toe Adjustment

Measure the alignment on an alignment rack. Wheel Alignment Measurement

Fig 1: Cam Bolt
Courtesy of GENERAL MOTORS COMPANY
If adjustment is necessary, remove the rear suspension link inner nut and bolt. DISCARD the nut bolt.
Rotate the rear suspension link inner bolt to adjust the toe angle. Wheel Alignment Specifications
Hand tighten the rear suspension link inner nut, but do not fully tighten.
NOTE: Do not tighten the new fasteners yet in order to allow for movement.
Re-inspect the rear toe angle and adjust as necessary.
Hold the NEW rear suspension link inner bolt and tighten the NEW rear suspension link inner nut.
CAUTION: Refer to Fastener Caution .

Tighten
- First pass: 90 N.m (66 lb ft)
- Final pass: plus 60 degrees
Repeat the procedure for the opposite rear wheel.