Installation Procedure

Apply lubricant to both ends of the steering gear boot (2).

Fig 1: Steering Gear Boot
Courtesy of GENERAL MOTORS COMPANY

NOTE: The steering linkage inner tie rod and the steering gear boot must be free of moisture and debris.
Install the steering gear boot with the NEW inner boot clamp (3) loosely attached.
NOTE: Ensure the larger end of the steering gear boot is firmly seated in the correct location on the steering gear.
Use the CH-22610 pliers in order to install the NEW inner boot clamp (1).

Fig 2: Larger Steering Gear Boot Clamp
Courtesy of GENERAL MOTORS COMPANY
Install the NEW outer boot clamp (2).

Fig 3: Locating Steering Gear Boot
Courtesy of GENERAL MOTORS COMPANY

NOTE: Ensure the small end of the steering gear boot is firmly seated in the correct location on the steering linkage inner tie rod.
Install the steering linkage inner tie rod nut (1).
Install the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .
Measure and adjust the front toe. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment .
Lower the vehicle.