Installation Procedure

Install the battery negative cable (4) to the vehicle and install battery negative retainers (3).

Fig 1: Negative Battery Cable
Courtesy of GENERAL MOTORS COMPANY
Install the ground terminal to the back panel and tighten the bolt (2) to 22 N.m (17 lb ft).
CAUTION: Refer to Fastener Caution .
Install the battery negative post clamp and tighten the nut (1) to 9 N.m (80 lb in).
Connect the body harness connector (1) to the current sensor.

Fig 2: Battery Current Sensor Connector
Courtesy of GENERAL MOTORS COMPANY
Install the body harness ground terminal (3) to the negative post clamp and tighten the nut (2) to 9 N.m (80 lb in).
Install the rear end trim finish panel. Refer to Rear End Trim Finish Panel Replacement
Install the rear compartment floor stowage compartment. Refer to Rear Compartment Floor Stowage Trim Compartment Replacement .